MAX211IDWR
Active5-V MULTICHANNEL 120KBPS RS-232 LINE DRIVER/RECEIVER WITH +/-9V OUTPUT & +/-15-KV ESD PROTECTION
MAX211IDWR
Active5-V MULTICHANNEL 120KBPS RS-232 LINE DRIVER/RECEIVER WITH +/-9V OUTPUT & +/-15-KV ESD PROTECTION
Technical Specifications
Parameters and characteristics for this part
| Specification | MAX211IDWR |
|---|---|
| Data Rate | 120 Kbps |
| Duplex | Full |
| Mounting Type | Surface Mount |
| Number of Drivers | 4 |
| Number of Receivers | 5 |
| Operating Temperature (Max) | 85 °C |
| Operating Temperature (Min) | -40 °C |
| Package Length | 0.295 in |
| Package Name | 28-SOIC |
| Package Width | 7.5 mm |
| Protocol | RS232 |
| Receiver Hysteresis | 500 mV |
| Type | Transceiver |
| Voltage - Supply (Maximum) | 5.5 V |
| Voltage - Supply (Minimum) | 4.5 V |
Pricing
Prices provided here are for design reference only. For realtime values and availability, please visit the distributors directly
| Distributor | Package | Quantity | $ | Updated |
|---|---|---|---|---|
| Digikey | Bulk | 145 | $ 2.08 | 1w |
| Cut Tape (CT) | 1 | $ 2.86 | 1w | |
| Tape & Reel (TR) | 1000 | $ 2.24 | 1w | |
| Texas Instruments | LARGE T&R | 1 | $ 2.46 | 30d+ |
| 100 | $ 2.03 | |||
| 250 | $ 1.46 | |||
| 1000 | $ 1.10 | |||
CAD
3D models and CAD resources for this part
Description
General part information
MAX211 Series
The MAX211 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5V supply. The devices operate at data signaling rates up to 120kbit/s and a maximum of 30V/µs driver output slew rate.
The MAX211 has both shutdown (SHDN) and enable control (EN). In shutdown mode, the charge pumps are turned off, V+ is pulled down to VCC, V− is pulled to GND, and the transmitter outputs are disabled. This reduces supply current typically to 1µA. EN is used to put the receiver outputs into the high-impedance state to allow wired-OR connection of two RS-232 ports. It has no effect on the RS-232 drivers or the charge pumps.
The MAX211 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5V supply. The devices operate at data signaling rates up to 120kbit/s and a maximum of 30V/µs driver output slew rate.
Documents
Technical documentation and resources
