Zenode.ai Logo
PDIP (N)
Integrated Circuits (ICs)

CD74FCT245E

Active
Texas Instruments

BICMOS FCT INTERFACE LOGIC OCTAL NON-INVERTING BUS TRANSCEIVERS WITH 3-STATE OUTPUTS

PDIP (N)
Integrated Circuits (ICs)

CD74FCT245E

Active
Texas Instruments

BICMOS FCT INTERFACE LOGIC OCTAL NON-INVERTING BUS TRANSCEIVERS WITH 3-STATE OUTPUTS

Technical Specifications

Parameters and characteristics for this part

SpecificationCD74FCT245E
Current - Output High15 mA
Current - Output Low64 mA
Logic TypeNon-Inverting, Transceiver
Mounting TypeThrough Hole
Number of Bits per Element8 bits
Number of Elements1
Operating Temperature (Max)70 °C
Operating Temperature (Min)0 °C
Output Type3-State
Package Length0.3 in
Package Name20-PDIP, 20-DIP
Package Width7.62 mm
Voltage - Supply (Maximum)5.25 V
Voltage - Supply (Minimum)4.75 V

Pricing

Prices provided here are for design reference only. For realtime values and availability, please visit the distributors directly

DistributorPackageQuantity$Updated
DigikeyTube 280$ 4.90<6d
TMEN/A 20$ 4.77<1d
Texas InstrumentsTUBE 1$ 4.6130d+
100$ 4.04
250$ 2.83
1000$ 2.28

CAD

3D models and CAD resources for this part

Description

General part information

74FCT245 Series

The CD74FCT245 is an octal bus transceiver with 3-state outputs using a small-geometry BiCMOS technology. The output stages are a combination of bipolar and CMOS transistors that limit the output high level to two diode drops below VCC. This resultant lowering of output swing (0 V to 3.7 V) reduces the power-bus ringing [a source of electromagnetic interference (EMI)] and minimizes VCCbounce and ground bounce and their effects during simultaneous output switching. The output configuration also enhances switching speed and is capable of sinking 64 mA.

The CD74FCT245 allows data transmission from the A bus to the B bus or from the B bus to the A bus, depending upon the logic level at the direction-control (DIR) input. The output-enable (OE\) input can be used to disable the device so that the buses are effectively isolated.

To ensure the high-impedance state during power up or power down, OE\ should be tied to VCCthrough a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.