Catalog
2-In/3-Out Any-to-Any Clock Mult/Jitter Atten
Key Features
• Three Input Clocks* Two Differential/CMOS inputs
• * One single-ended/CMOS input
• * Any input frequency from 1kHz to 1250MHz (1kHz to 300MHz for CMOS)
• * Inputs continually monitored for activity and frequency accuracy
• * Automatic or manual reference switching
•
• Low-Bandwidth DPLL* Programmable bandwidth, 14Hz to 500Hz
• * Attenuates jitter up to several UI
• * Freerun or digital hold on loss of all inputs
• * Digitally controlled phase adjust
•
• Low-Jitter Fractional-N APLL and 3 Outputs* Any Output Frequency from <1Hz to 1035MHz
• * High-resolution fractional frequency conversion with 0ppm error
• * Easy-to-configure, encapsulated design requires no external VCXO or loop filter components
• * Each output has independent dividers
• * Output Jitter Typically 0.16 to 0.28ps RMS (12kHz to 20MHz integration band)
• * Outputs are CML or 2xCMOS, can interface to LVDS, LVPECL, HSTL, SSTL and HCSL
• * In 2xCMOS mode, the P and N pins can be different frequencies (e.g. 125MHz and 25MHz)
• * Per-output supply pin with CMOS output voltages from 1.5V to 3.3V
• * Precise output alignment circuitry and per-output phase adjustment
• * Per-output enable/disable and glitchless start/stop (stop high or low)
•
• General Features* Automatic self-configuration at power-up from internal EEPROM; up to four configurations, pin-selectable
• * Numerically controlled oscillator mode
• * Spread-spectrum modulation mode
• * SPI or I2C processor Interface
• * Tiny 5x5mm QFN package
• * Easy-to-use evaluation software
• * ZL30253 can be ordered with up to four user-defined, factory-programmed device configurations
Description
AI
[CREATE AND SAMPLE YOUR CUSTOM ZL30253 HERE](https://clockworks.microchip.com/microchip/design/inputZL)
The ZL30253 is a flexible, high-performance, clock multiplier/jitter attenuator IC. From any input clock frequency 1kHz to 1250MHz the ZL30252 can produce frequency-locked output frequencies from 1Hz to 1035MHz and as many as 3 differential or 6 CMOS output clock signals. Output jitter is typically 0.16 to 0.28ps RMS (12kHz to 20MHz). Automatic self-configuration from internal EEPROM allows clock signals to be available immediately after power-up or reset.