Catalog
4-Port USB 2.0 Hi-Speed Hub Controller
Key Features
• Compliant with USB 2.0 Specification
•
• Hub Controller IC with Four Downstream Ports
•
• MultiTRAK&trade Technology Provides One Transaction Translator Per Port
•
• Default Configuration with Pin Selectable Options
•
• Flexible OEM Configuration Options
•
• 64-Pin TQFP RoHS compliant package
•
• Integrated 1.8V regulator
•
• Integrated Termination and Pull-Up/Pull-Down Resistors
•
• Internal Short Circuit Protection of DP and DM Lines
•
• On-Chip Oscillator Uses Low Cost 24MHz Crystal
•
• Supports Ganged or Individual Over-Current Protection and Power Control
•
• 3.3V I/O with 5V tolerance
•
• Pin-to-pin Compatible with USB20H04
•
• Customize Vendor ID, Product ID, and Device ID
•
• Select whether the hub is part of a compound device (When any downstream port is permanently hardwired to a USB peripheral device, the hub is part of a compound device)
•
• Select the presence of a permanently hardwired USB peripheral device on a port by port basis
•
• Configure the delay time for filtering the over-current sense inputs
•
• Configure the delay time for turning on downstream port power
•
• Configure the polarity of down stream port power control signals
•
• Indicate the maximum current that the 4-port hub consumes from the USB upstream port
•
• Indicate the maximum current required for the hub controller
•
• Select Downstream Ports as Non-Removable Ports
•
• Select Downstream Ports as Disabled Ports
•
• Enable/Disable Downstream Port LED Indicators
•
• Select Downstream Port Power Control and Over-Current Detection on a Ganged or Individual Basis
•
• Select Downstream Port Power Control Polarity
Description
AI
The USB2504 4-port hub controller is fully compliant with the USB 2.0 Specification and does not require firmware development. When connected to a USB high-speed host, the four downstream ports can operate at low-speed (1.5Mb/s), full-speed (12Mb/s), or high-speed (480Mb/s). As required by the USB 2.0 Specification, the USB2504 is fully backward compatible with legacy USB full-speed hosts.
A default configuration is available in the USB2504 following a reset. This configuration may be sufficient for some applications when it is desired to save the expense of an EEPROM. The controller may be configured from a microcontroller or an external EEPROM. When using the microcontroller interface, the USB2504 appears as a SMBus slave device. The EEPROM interface supports a 2-wire I²C device.
All required resistors on the USB ports are integrated into the USB2504. This includes all series termination resistors on D+ and D- pins and all required pull-down and pull-up resistors on D+ and D- pins. The over-current sense inputs for the downstream ports have internal pull-up resistors.
Microchip's complimentary and confidential [MicroCHECK](https://www.microchip.com/en-us/support/design-help/design-check-services) design review service, which offers insight from the initial concept to the final PCB layout, is available to customers who are using our products in their projects. You can confidently submit your design materials in a secure and private setting, and our expert engineers will provide individualized feedback to enhance your design. MicroCHECK design review service is subject to Microchip's [Program Terms and Conditions](https://www.microchip.com/en-us/support/design-help/design-check-services/design-check-services-program-terms-and-conditions) and requires a myMicrochip account.