M24M01-A125 Series
1 Mbit Serial I2C bus EEPROM with configurable device address and software write protection registers
Manufacturer: STMicroelectronics
Catalog
1 Mbit Serial I2C bus EEPROM with configurable device address and software write protection registers
Key Features
• I²C interface
- Compatible with the following I²C bus modes:1 MHz (Fast-mode Plus)400 kHz (Fast-mode)100 kHz (Standard-mode)
• Memory
- 1-Mbit (128-Kbyte) of EEPROM
- Page size: 256-byte
- Additional 256-byte identification page
• Supply voltage
- Wide voltage range: 1.6 V to 5.5 V
• Temperature
- Operating temperature range: -40 °C to +85 °C
• Fast write cycle time
- Byte and page write within 4 ms (typically 3 ms)
• Performance
- Enhanced ESD/latch-up protection
- More than 4 million write cycles
- More than 200-year data retention
- Fast wake-up time (less than 5 µs)
• Ultra-low power current consumption
- 350 nA (typical) in standby mode
- 100 µA (typical) for read current
- 400 µA (typical) for write current
• Advanced features
- Configurable device address register
- Device type identifier register (in read-only)
- Preprogrammed device address
- Software write protection register
- Hardware write protection of the whole memory array
- Random and sequential read modes
• Packages
- SO8N, TSSOP8, UFDFPN8, and WLCSP5 (ECOPACK2 compliant)
Description
AI
The M24M01E-F is a 1-Mbit I²C-compatible EEPROM (electrically erasable programmable memory) organized as 128 K × 8 bits. It can operate with a supply voltage from 1.6 V to 5.5 V with a clock frequency up to 1 MHz, over an ambient temperature range of -40 °C to +85 °C.
The device offers three 8-bit registers, namely: the device type identifier (DTI) register, the configurable device address (CDA), and the software write protection (SWP) register.
The device offers an additional 256-byte page, called the identification page. This page can be used to store sensitive application parameters, which can later be permanently locked in read-only mode.
The M24M01E-F is available in the standard 8-pin TSSOP8, SO8N, UFDFPN8, and in the 5-ball wafer level chip scale packaging (WLCSP) with the WC pin.
On demand, the EEPROM can be delivered with a preprogrammed and locked device address.