MC100EP90 Series

Translator, Triple ECL Input to LVPECL / PECL Output

Catalog

Translator, Triple ECL Input to LVPECL / PECL Output

Part	Supplier Device Package	Output Type	Output Signal	Mounting Type	Input Signal	Number of Circuits	Operating Temperature [Max]	Operating Temperature [Min]	Translator Type	Package / Case [y]	Package / Case	Package / Case [x]	Channel Type	Channels per Circuit
ON Semiconductor MC100EP90DTR2G	20-TSSOP	Differential	LVPECL, PECL	Surface Mount	ECL	1	85 °C	-40 °C	Mixed Signal	4.4 mm	20-TSSOP	0.173 in	Unidirectional	3
ON Semiconductor MC100EP90DTG	20-TSSOP	Differential	LVPECL, PECL	Surface Mount	ECL	1	85 °C	-40 °C	Mixed Signal	4.4 mm	20-TSSOP	0.173 in	Unidirectional	3

Catalog

Translator, Triple ECL Input to LVPECL / PECL Output

Key Features

• 260 ps Typical Propagation Delay

• Maximum Frequency > 3 GHz Typical

• Voltage Supplies VCC= 3.0 V to 5.5 V, VEE= -3.0 V to -5.5 V, GND = 0 V

• Open Input Default State

• Safety Clamp on Inputs

• Fully Differential Design

• Q Output will default LOW with inputs open or at VEE

• VBBOutput

• These are Pb-Free Devices

Description

The MC10/100EP90 is a TRIPLE ECL TO LVPECL/PECL translator. The device receives differential LVECL or ECL signals and translates them to differential LVPECL or PECL output signals. A VBBoutput is provided for interfacing with single ended LVECL or ECL signals at the input. If a single ended input is to be used the VBBoutput should be connected to the D input. The active signal would then drive the D input. When used the VBBoutput should be bypassed to ground by a 0.01 F capacitor. The VBBoutput is designed to act as the switching reference for the EP90 under single ended input switching conditions, as a result this pin can only source/sink up to 0.5mA of current.To accomplish the level translation the EP90 requires three power rails. The VCCsupply should be connected to the positive supply, and the VEEconnected to the negative supply.The 100 Series contains temperature compensation.